Precor EFX546 Servisní příručka stáhnout pdf (Strana 82)

C546 Elliptical Fitness Crosstrainer

Page 82

Procedure 7.15 - Replacing the Input Pulley Belt

1. Set the on/off switch in the “off” position, then unplug the power cord from the wall outlet.

WARNING

Before continuing with this procedure, review the Warning and Caution statements listed in

Section One, Things You Should Know.

2. Remove the rear cover as described in Procedure 7.1.

3. Remove the stairarm assemblies as described in Procedure 7.24.

4. Remove the crankarm assemblies as described in Procedure 7.12.

5. Remove the magnet assembly as described in Procedure 7.20.

6. Remove the input drive assembly per Procedure 7.17, steps 6-9.

7. Carefully, lay the EFX on it’s side. Remove the bolts that retain mounting plate for the input

module and on/off switch. Swing the mounting plate away from the drive unit.

8. Remove the left and right tension bolts, locking tabs and brackets. Slide the step up pulley

assembly with both the step up and input belts out of the drive unit.

9. Remove the input pulley belt. Set the replacement input pulley belt in it’s mounting position

on the step up pulley assembly.

10. Set the step up pulley assembly with the step up and input belt at it’s mounting position in

the drive unit. Replace the tensioning bolts, locking tabs and brackets removed in step 8.

Thread the left and right tension bolts into the step up pulley shaft.

11. Complete the installation per Procedure 7.17, steps 10-17.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 117 118

Žádné komentáře

Precor EFX546 Servisní příručka Strana 82